While Operating - DeWalt DXGSE Operator's Manual

ENGLISH
SAFETY - Continued
• Always stop the engine and allow it to
cool before filling the tank. Never
remove the fuel tank cap or add fuel
when the engine is hot. Always loosen
the fuel tank cap slowly to relieve any
pressure in the tank before fueling.
• Always mix and add fuel in a clean, well-
ventilated outdoor area where there are
no sparks or flames. DO NOT smoke.
• Never operate the unit without the fuel
cap securely in place.
• Avoid creating a source of ignition for
spilled fuel. Wipe up any spilled fuel
from the unit immediately, before
starting the unit. Move the unit at least
30 ft. (9.1 m) from the fueling source
and site before starting the engine. DO
NOT smoke.
• Never start or run the unit inside a
closed room or building. Breathing
exhaust fumes can kill. Operate this unit
only in a well-ventilated outdoor area.

WHILE OPERATING

• Wear safety glasses or goggles that
meet current ANSI / ISEA Z87.1
standards and are marked as such.
Wear ear/hearing protection when
operating this unit. Wear a face mask or
dust mask if the operation is dusty.
• Wear heavy long pants, boots, gloves
and a long sleeve shirt. Do not wear
loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair
above shoulder level.
• Adjust the handle to provide the best
grip, if applicable.
• Use the unit only in daylight or good
artificial light.
• Avoid accidental starting. Be in the
starting position whenever pulling the
starter rope. The operator and unit must
be in a stable position while starting.
Refer to Starting and Stopping.
• Use the right tool. Only use this tool for
its intended purpose. Only use the unit
as described in this manual.
• Always hold the unit with both hands
when operating. Keep a firm grip on
both handles or grips.
• Do not overreach. Always keep proper
footing and balance. Take extra care
when working on stairs, steep slopes or
inclines. To avoid serious injury, do not
operate the unit while on a ladder or a
roof.
• Keep hands, face, and feet away from
all moving parts. Do not touch or try to
stop moving parts.
• Do not touch the engine, gear housing
or muffler. These parts get extremely
hot from operation, even after the unit
is turned off.
• To prevent serious personal injury,
avoid arm contact with the engine
while operating the unit. The engine
may be extremely hot.
• Do not operate the unit faster than the
speed needed to do the job. Do not run
the unit at high speed when not in use.
• Do not force the unit. It will do a better,
safer job when used at the intended rate.
• Always turn the unit off when
operation is delayed or when carrying
the unit from one location to another.
Make sure all moving parts come to a
complete stop.
• Before setting the unit down, always
make sure the engine is off and all
moving parts have stopped.
6