Troubleshooting - TACKLIFE SGP17AC User Manual

Separate collection of the used products and packaging allows materials to be
recycled and used again. Re-use of recycled materials help sprevent environ-
mental pollution and reduces the demand for raw materials. Local regulations
may provide for separating collection of electrical products from the household, at municipal
waste sites or by the retailer when you purchase a new product.

TROUBLESHOOTING

TROUBLE!
Spraying too much material.
MATERIAL
RUNS OR
Spraying too slowly.
DRIPS.
Spraying too close.
Viscosity too thin.
Nozzle loose
MATERIAL
Nozzle breaks
DRIPS FROM
Y-type seal ring of nozzle breaks
NOZZLE
Material accumulated /clog
inside nozzle
Sprayer too far from surface.
TOO MUCH
Too much material being
OVER SPRAY.
sprayed.
Spray nozzle/tip clogged.
Y-type seal ring of nozzle missing
Pickup tube loose or clogged.
LITTLE OR NO
Canister loose
MATERIAL
Quick refill lid loose
BEING
RELEASED.
Spray gun unit not fully attached
to the power unit
Flow control knob setting too low
Air inlet blocked
Material too thick.
MATERIAL
Viscosity of material is too high.
BEING
SPRAYED IS
SPLATTERING
WHAT'S WRONG?
Reduce paint flow by turning material
adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
Screw nozzle tight
Change
Change
Clean
Reduce distance to surface.
Reduce paint flow by turning flow
control knob
Clean nozzles.
Add seal ring to nozzle and assemble
in place
Check tube.
Screw canister tightly in place
Screw quick refill lid tight in place
Check attachment of spray gun unit
Increase flow control setting
Clean or change air filter
Thin material per
recommendation.
Thin material per manufacturer
recommendation.
- 21-
WHAT TO DO...
manufacturer