Before Requesting Service - Panasonic NN-SN975S Owner's Manual

Before Requesting Service

These things are normal:
The oven causes in-
terference with my TV.
Steam accumulates
on the oven door and
warm air comes from
the oven vents.
PROBLEM
Oven will not turn on.
Oven will not start
cooking.
The Glass Tray
wobbles.
When the oven is
operating, there is
noise coming from
the glass tray.
The indication light
appears in the
Display Window.
The oven stops cook-
ing and "H00", "H97" or
"H98" appears in the
display window.
F0003BP80AP_En.indd 27 F0003BP80AP_En.indd 27
Some radio, TV, Wi-Fi, cordless telephone, baby monitor, blue tooth
or other wireless equipment interference might occur when you
cook with the microwave oven. This interference is similar to the
interference caused by small appliances such as mixers, vacuums,
blow dryers, etc. It does not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food.
Most of the steam and warm air are removed from the oven by
the air which circulates in the oven cavity. However, some steam
will condense on cooler surfaces such as the oven door. This is
normal. After use, the oven should be wiped dry (see page 28).
POSSIBLE CAUSE
The oven is not plugged in
securely.
Main circuit breaker or main
fuse is tripped or blown.
There is a problem with the
outlet.
The door is not closed
completely.
Start Pad was not pressed
after programming.
Another program is already
entered into the oven.
The program is not correct.
Stop/Reset Pad has been
pressed accidentally.
The Glass Tray is not
positioned properly on the
Roller Ring or there is food
under the Roller Ring.
The Roller Ring and oven
bottom are dirty.
The CHILD LOCK was
activated.
This displaying indicates a
problem with the microwave
generation system.
27
REMEDY
Remove plug from outlet, wait
10 seconds and re-insert.
Reset main circuit breaker or
replace main fuse.
Plug another appliance into the
outlet to check if it is working.
Close the oven door securely.
Press Start Pad.
Press Stop/Reset Pad to can-
cel the previous program and
enter new program.
Program again according to
the Operating Instructions.
Program oven again.
Take out Glass Tray and Roller
Ring. Wipe with a damp cloth
and reset Roller Ring and
Glass Tray properly.
Clean these parts according to
Care and Cleaning of your
Microwave oven (see page 26).
Deactivate LOCK by pressing
Stop/Reset Pad 3 times.
Please contact an authorised
Service Center (see page 28).
2015/1/6 15:28:36 2015/1/6 15:28:36