Download Print this page
Progressive Industries EMS-LCHW30 Operating And Installation Manual

Progressive Industries EMS-LCHW30 Operating And Installation Manual

Electrical management system

Advertisement

Quick Links

Progressive Industries Warranty
Progressive warrants its products are free from defects in materials and
workmanship for a period of three years. This is in lieu of all other warranties,
obligations, or liabilities expressed by the company. In the event that a properly
installed EMS proves defective under normal use, Progressive will repair or replace
the device at its discretion.
With the Hardwired EMS it is not necessary to return the entire system for repair.
This product was specifically designed be modular therefore, any part of the EMS
can be replaced without removing the entire product. For technical support call
919-462-8280.
Once technical support has properly diagnosed the problem if any, they will send
you a replacement part. Do not remove damaged part unless instructed to do so; this
will aid you when it comes time to install the replacement part.
When you receive your replacement part or parts, inside the box will be a return
address label with RGA number, simply use the same box, and return label to ship
back the damaged part.
The address below is strictly a mailing address, please do not try, or attempt to visit
our facility during business hours, the company is not properly staffed or equipped
to handle on site repair work. All returns must go through technical support.
Progressive Industries
414B Airport Blvd.
Morrisville, North Carolina 27560
The unit should be properly packaged, with the postage paid and the following
information:
1. Date of purchase
2. A detailed explanation of the defect.
Progressive cannot assume responsibility for acts of god, alterations, shipping
handling, or any other factors not under the control of Progressive Industries.
Progressive has no responsibility for installation, personal injury, property damage,
incidental, contingent, or consequential damages of any kind resulting from defects
or failure of the unit to function.
The remedy for breach of this warranty is limited to the repair or replacement of the
defective product at Progressives option. In no case shall the liability prescribed by
law exceed the purchase price. Some states do not allow exclusion or limitation of
incidental or consequential damages or allow disclaimer, modifications, or
limitations on how long a warranty last, therefore the above warranties may not
apply to you. This warranty gives you certain legal rights, and you may have other
rights, which may vary from state to state.
(rev a)
EMS
Electrical Management System
The complete operating and
installation guide for:
EMS-LCHW30
Rated at 120V/30A
Manufactured by:
Progressive Industries
Incorporated
Morrisville, North Carolina
919-462-8280
www.progressiveindustries.net

Advertisement

loading

Summary of Contents for Progressive Industries EMS-LCHW30

  • Page 1 Progressive cannot assume responsibility for acts of god, alterations, shipping Manufactured by: handling, or any other factors not under the control of Progressive Industries. Progressive has no responsibility for installation, personal injury, property damage, incidental, contingent, or consequential damages of any kind resulting from defects or failure of the unit to function.
  • Page 2 Troubleshooting guide Common installation mistakes: Features: 1.Check cable connections High low voltage protection: Whenever source power falls below 104 Volts, or Unplug open control box and check connections. Look at rise above 132 volts the EMS automatically shut down power to the RV. Once the small wires located under the input connections, and make AC source rises above 104-volts, or below the 132-volt level the time delay sure the conductor colors match (small black wires and black...
  • Page 3: Error Code Chart

    • will the delay light flash and ultimately bring power to the RV. Refer to your Progressive Industries recommends you have a certified error code chart card that was provided or see below for details. electrician or an authorized dealer perform the installation 5.
  • Page 4 8. Remove control box cover, detach display card and back off four Installation instructions for screws from top of contactor and two ground lugs on side of enclosure. 9. Take the jumper cable with 3 conductor strip, and slide it through the Models: EMS-HW30C input side of the EMS control box Then connect black above little black 1.