lumishore SY300 SUPRA Installation Manual

SY300 SUPRA DC Driver Installation Manual
SY300 SUPRA DC Driver Installation Manual
SY300 Light must be installed according to instructions 45-0082
Before you start...
• High Intensity LED light – Do not stare into the LED module at close proximity.
• Always ensure that the vessel's power source is disconnected or isolated prior to installation.
• A qualified professional should carry out both the electrical and mechanical installation.
If in doubt please contact LUMISHORE. refer to product support section.
• The Driver supplies voltage and current to the Underwater lights. Under no circumstances
should the light cable be cut and connected directly to voltage.
• Always use a suitable fuse or circuit breaker to protect the complete system. Each light to be
individually fused.
• Never try to install or remove light with the vessel in the water - Contact Lumishore for advice.
• Lights should not be exposed to any temperatures in excess of 150°F (65°C). For example,
next to hot engine components or where exhaust emissions could be expelled onto the light
while underwater.
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | Info@Lumishore.com
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | Sales@LumishoreUSA.com
Please read the following pages before attempting installation to ensure
complete understanding of the LUMISHORE SY300 SUPRA.
45-0182-RevB
1
www.Lumishore.com