Robus R7LEDTWW-01 Quick Start Manual

Speci cation:

Installation:

1. Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste
(WEEE marked with crossed out wheelie bin symbol).
2. Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection
centre for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a
replacement.
3. This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It
is important that it is separated from normal household waste and recycled in the WEEE chain
4. The "crossed out wheelie bin symbol" on a product indicates this equipment must not be disposed of in normal
household but should be disposed of according to local WEEE regulations
LED Group
Western Retail Park
Nangor Road
Dublin 12
Ireland
Issue 1 270313
7W TRACK SPOT WARM
WHITE,WHITE
7W TRACK SPOT WARM
WHITE,BRUSHED CHROME
R7LEDTWW-01
R7LEDTWW-13
Please read instructions before commencing installation and retain for
future reference.
Supply:
Total power:
Power factor:
Beam Angle:
CCT L :
100
CRI at L :
100
Temperature range
Length
width:
Projection:
Box Qty:
Warranty:
Weight:
Compatible with Robus single circuit track (R1T,R2T and R3T)
!Electrical products can cause death or injury, or damage to property. If in any
doubt about the installation or use of this product, consult a competent
electrician.
1 Ensure mains supply is switched off before commencing work
2 To attach luminaires to the track, offer it up at 90° to the track and rotate until parallel to
the track and the lock tab engages.
Note: The track is not symmetric. There are two conductors on one side, and one
on the other. Check alignment of luminaire before rotating into position
3 Connect power track.
4 To remove fitting from the track; pull down catch and rotate 90°
This product has no serviceable parts, if any part is damaged , please discontinue from use
and report to the supplier.

Information for the Product user

The Installation must be carried out by an electrician
Tel: +353 1 7099000
Fax: +353 1 7099060
Email: info@led.ie
Website: www.led.ie
220~240V; 50~60Hz
9W
0.8
30
3000K
80
5 C< Ta < 40 C
O O
116mm
35mm
142mm
1
3 years
0.3kg
ISO 9001:2008
Q UAL IT Y ASSU RE D CO MPANY
Page 1