Advertisement
4.1 Music play/ pause: short press Play/Pause button to play/pause the music.
4.2 Next/previous song: long press 1s Next Song button to the next song, long press 1s Previous Song button to
the previous song.
4.3 Volume+/-: short press Volume+ button to increase the volume, short press Volume- button to decrease the
volume.
5. Talking Mode:
5.1 Short press power on/off button to answer incoming call, short press power on/off button to end a call.
5.2 When a call coming, long press 1s power on/off button to refuse a call.
6. Siri:
Short press power on/off button twice to start Siri function.
7. Battery:
When voltage is below 3.4V (playtime around 30min, low battery alarm then every 5 minutes a reminder);
The LED is Solid red (solid red& breathing white when working and charging) when charging speakers;
Fully charged the Red LED is off.
8. TWS function:
8.1 Power on/off:
8.1.1 Power on: Long press Power on/off button for three seconds on both speakers, the LED is flash white,
power on.
8.1.2 Power off: Long press Power on/off button for three seconds on either speaker, both speakers turn off.
8.2 TWS pairing mode:
8.2.1 Powering on the speakers without paired with any device.
8.2.2 Pressing and holding Bluetooth button of the two speakers for 1 second until the LED indicators flash red
and white, and a tone 1 will be heard.
8.2.3 After pairing successfully, a tone will be heard, the main speaker flashes white, the other breath WHITE
every 10S.
8.3 Disconnect TWS: Short press Bluetooth button twice on either speaker, the main speaker keeps playing and
LED breathe white every 10s, the other one goes into to the pairing mode, ready for pairing and LED is flash
white.
8.4 Bluetooth connection mode:
8.4.1 1st time connect: When TWS is ready to pair device, turn on the BT on your device and choose
"Brookstone BSSK9015". After connected with device, both 2 speakers breath WHITE every 10S. The main speaker
will act as left channel and the other as right channel.
8.4.2 If the speaker connected with a device before: it will automatically go into pairing mode and connected
with that device when powered on. (For Apple device, if power on the speaker firstly, then turn on BT on the
Advertisement
