NVR Registration 1. Supply power to the camera using 12V input 2. Run IP installer and select Search button to or POE cable. Synchronize the network same as scan the thermal camera with the same network. the computer. (Camera default IP address: 192.168.0.100. Set the computer with the same e.g.) 192.168.0.10) 3.
Page 3
8 . Click Event Max Temperature and enter the [ON] temperature of 2°C higher than the person Event Report identified in 5. (e.g. in environment where a person is detected at 32°C, set the upper alarm limit to 34°C.) DC-TH Series...
Page 4
9. Connect the camera to the NVR and select 10. Scan - Select Third Party Scan. camera registration by clicking on the right mouse button. 11. Select Advanced Setup. 12. Change the mode to Manual. Thermal Nerwork Camera Quick Guide...
Page 5
15. Select IP address mode , enter camera IP 16. If scan is done, close Thrid Party Scan, address and scan. right click and select add camera. (If camera IP adress is set as default , enter 192.168.0.100). DC-TH Series...
Page 6
17 . Enter camera ID and password , then cam- 18. Select the Setting. era is registered and live view is available. Select Apply button and camera registration is done. (Default : admin /Thermal#) 19. Camera - Set the stream 1 resolution 800 x 600 and apply.
Page 7
Temperature MAX Alarm Setting 1. Select the Setting. 2. Enter Event - Video Analysis - Motion, select Actions 3. Select the Alarm out. 4. Select Beep, click ok and apply. NVR triggers beep sound when temperature is detected. DC-TH Series...