Sealey SSG701.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to
these instructions and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 Familiarise yourself with the application, limitations and potential hazards peculiar to the spray Gun.
 WARNING! Disconnect the spray gun from the air supply before changing accessories, servicing or
performing any maintenance.
 Maintain the spray gun in good condition. (Use an authorised service agent).
 Replace or repair damaged parts. Use recommended parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
 Keep the spray gun clean for best and safest performance.
 Ensure that the compressed air system can supply the spray gun
air consumption (4.2cfm).
 Wear approved safety respiratory protection and safety eye goggles.
 If spraying isocyanate based finisher, wear approved respirator/clean
air breathing apparatus and cover exposed skin with latex gloves
and an impervious hooded coverall.
 Remove ill fitting clothing. Remove ties, watches, rings and other loose
jewellery and tie back long hair.
 Locate the spray gun in a suitable work area. Keep area clean and
tidy and free from unrelated materials and ensure that there is
adequate ventilation and lighting.
 Keep children and unauthorised persons away from the work area.
 When not in use, ensure that the air supply is turned off.
 Avoid unintentional operation of spray gun.
 DO NOT point spray gun at yourself, other persons or animals.
 DO NOT direct air from the air hose at yourself, other
persons or animals.
 DO NOT carry the spray gun by the hose, or yank the hose from
the air supply.
 DO NOT exceed the maximum air pressure of 35psi.
 DO NOT use the spray gun for any purpose other than that for which it is designed.
 DO NOT allow untrained persons to operate the spray gun.
 DO NOT get the spray gun wet or use in damp or wet locations or in areas where there is condensation.
 DO NOT operate the spray gun if any parts are missing or damaged as this may cause failure
and/or personal injury.
 When not in use, disconnect the spray gun from the air supply, clean thoroughly and store safely.
2. INTRODUCTION & SPECIFICATIONS
Constant bleed type spray gun for use on simple applications. Supplied with a aluminium suction feed pot. Suitable
for use with waterborne paints.
Standard set-up:. . . . . . . . . . . . . . . . . . . . . . 1.3mm
Air pressure: . . . . . . . . . . . . . . . . . . . . . . . . . . 35psi
Air consumption:. . . . . . . . . . . . . . . . . . . . . . 4.2cfm
INSTRUCTIONS FOR:
LOW PRESSURE SPRAY GUN
MODEL No:
Original Language Version
SSG701.V2
SSG701.V2 Issue: 2 -
18/01/10