Advertisement
2. INTRODUCTION & SPECIFICATION
2.1. INTRODUCTION
Weatherproof composite spotlight with carry handle. Integral stand keeps lens and battery case off the floor and permits light to be directed
where it is needed. Ø170mm Lens with halogen bulb produces 5-million candle power of intense white light and is suitable for a variety of
industrial, domestic and leisure applications. Supplied with two sealed 6Volt 4Ah batteries, in-vehicle charger and 230 - 12Volt battery
charger pack.
Weight: . . . . . . . . . . . . . . . . . 3.5kg
Lens Diameter: . . . . . . . . . 170mm
Spares:
AK437.V3-01
Bulb - Halogen H3 12V 100W
AK437.V3-02
Switch
AK437.V3-03
Mains Charger 12V 300mA
AK437.V3-05
Battery - 6V 4Ah (x2)
AK437.V3-06
Vehicle Accessory Lead
3. OPERATION
3.1. OPERATION
WARNING! Ensure that you read, and fully understand the safety
instructions before use.
Reminder: This spotlight is designed for intermittent use only. Continuous
use may damage the unit.
1. Charge the batteries before use.
IMPORTANT: Turn off spotlight whilst charging. Failure to do so will
damage the charger plug/vehicle plug.
2. Turn spotlight 'On' and 'Off' by the rocker switch (fig.3.A) on the main
body.
3. The spotlight has a fixed carrying handle and two adjustable standing
supports (fig.1.C).
3.2. BATTERY CHARGING
WARNING! Ensure that you read, fully understand, and apply the safety
instructions relating to the batteries and charger before use.
IMPORTANT WARRANTY INFORMATION:
The battery pack fitted to this cordless tool is considered to be a consumable item and its ability to
accept charge will reduce over time.
We will warranty it against mechanical and electrical defect for a period of one year - this does not
cover fair wear and tear. If the battery is not properly charged before first use, or regularly
conditioned, its capacity will diminish. Under these circumstances we will not replace the battery pack
even if it is less than one year old.
3.2.1. Mains Charger plug
1. Ensure the spotlight is turned 'Off' and then plug the charger adaptor (fig.2) into the jack inlet
(fig.3.B) on the spotlight body. Stand the spotlight in a safe location ready to charge.
2. Plug charger into the mains supply.
3. Allow approximately 20 hours for the initial charge and 16 hours for
subsequent charges.
4. When full charge has been reached, switch off the mains supply and unplug
the charger from the mains and then from the spotlight. The spotlight is now
ready for use.
5. Store the charger in a safe, dry location.
NOTE: a) Fully charged batteries will last for approximately 30 minutes.
b) DO NOT fully discharge the batteries before recharging.
3.2.2. Vehicle Charger plug
1. Ensure the spotlight is turned 'Off' and then plug the vehicle charger plug
(fig.4) into the jack inlet (fig.3.B) on the spotlight body. Stand the spotlight in
a safe location ready to charge.
2. Insert the charger plug into the vehicle's accessory socket (12V only).
3. Allow approximately 20 hours for the initial charge and 16 hours for
subsequent charges.
4. When full charge has been reached, unplug the adaptor from the vehicle's
accessory socket and then from the spotlight. The spotlight is now ready for
use.
5. Store the charger plug adaptor in a safe, dry location.
NOTE: Charging the spotlight from a 12 volt vehicle socket will drain the vehicle's
battery, unless the engine is running.
Charging Time (approx.): . . . 16hrs
Operating Time (approx):. . 30mins
Original Language Version
B
A
fig.3
fig.4
C
fig.1
fig.2
AK437.V3
Issue: 2 - 18/01/12
Advertisement
