Installation - Glacier bay 1521US-24-313 Use And Care Manual

Installation

1
Installing the Drain Kit
□ Apply the sponge washer (3) to the underside of the
strainer body (2).
□ Insert the strainer body (2) into the sink.
□ Assemble the rubber washer (4), the paper washer (5) and
locknut (6) onto the strainer body (2) from underneath the
sink.
□ Hand tighten the locknut (6). Do not over tighten the
locknut as it may split or deform the strainer body.
□ Assemble the plastic joint (7) and connecting nut (8) onto
the strainer body (2) from underneath the sink.
□ Insert the screener (1) into the strainer.
2
Installing the Base
A thorough inspection must be made before installation and any
damages or missing parts must be promptly reported. Do not
proceed with the installation. Do not dispose of packaging before
you are satisfied with your new sink.
□ Unpack the unit and place the sink (B) on a blanket or
cardboard to protect the surface.
□ Turn the cabinet (A) upside down onto the protective
surface.
□ Gently attach the cabinet base (C) onto its proper location.
Using the supplied cabinet base screws (AA), attach the
base (C) to the cabinet (A).
□ Gently place the cabinet upright.
1. Screener
2. Strainer Body
3. Sponge Washer
4. Rubber Washer
5. Paper Washer
6. Locknut
7. Plastic Joint
8. Connecting Nut
6
CAUTION: Do not place side load onto feet when righting
the cabinet.
C
A
AA