Table of Contents
Advertisement
Universal Transmitter (Option)
This device complies with
P a r t
15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this
device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of
the device.
Changes and modifications to this system by other than
an authorized service facility could void authorization
to
use this equipment.
Programming the Transmitter
Do not use the universal transmitter with any garage
door opener that does not have the "stop and reverse"
safety feature. This includes any garage door opener
model manufactured before April 1, 1982.
Be sure that people and objects
are clear of the garage
door you are programming.
Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. If you have previously programmed a transmitter
channel, proceed to Step 2. Otherwise, hold down
the two outside buttons on the universal transmitter
until the amber light begins to flash rapidly
(approximately 20 seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
2. Decide which one of the three channels you want
to program.
Advertisement
Table of Contents
