Advertisement
L2 Repair Document
Screwdriver
(TORX6)
4.3 Disassembly process
The steps of disassembly one touch 902 are as below.
This module should only be disassembled from bottom to top
Step 1: Remove the battery cover and battery.
Step2: Take off the 7 screws from the furnished frame by screw driver.
Step 3: Separate the furnished frame from furnished front casing.
Rev.
1.1
All rights reserved. Transfer, copy, use and communication of this file is prohibited without authorization.
By NCK Team
Soldering iron
one touch 902 Level 2 Repair Document
Camera Jig
.
Page
12/28
Advertisement
