Advertisement
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety precautions
Risk of explosion
Only connect the battery cables when the mains supply is disconnected.
Never use the charger in a confined area without adequate ventilation and air flow.
Before removing the battery terminals turn off the device.
During the loading process, explosive gases can be generated, therefore fire, sparking etc.
should be avoided.
The red battery terminal has to be connected to the positive pole and the black battery ter-
minal to the minus pole – DO NOT mix them up.
NEVER use the booster if the charging cables or the battery terminals are damaged. Do not
shake it or push it during loading.
NEVER try charging a frozen battery.
Use only the fuses that are available in the booster on delivery – NEVER install greater fuses.
Clean the battery carefully before loading and check the battery voltage.
Features
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Indoor use only!
Keep away from liquids at all times!
Item 30567, 30568
№
Name
1
Amperemeter
2
Power LED (green)
3
Polarity check LED (red)
4
Charge status LED (yellow/green)
Charge voltage switch: engine start
(30568),
charging
5
(30568), charging with 6 V (30567),
fast or slow charging with 12 V
with
24 V
Page 3
04
2021-1
Advertisement
