Conformity; Energy Saving; Before First Use - Haier HBB 177 TNF Manual

Conformity

By placing the
safety, health and environmental requirements which are applicable in legislation for this product.

Energy Saving

For better energy saving we suggest :

Installing the appliance away from heat sources and not exposed to direct sunlight and in a
well ventilated room.

Avoid putting hot food into the refrigerator to avoid increasing the internal temperature
and therefore causing continuos functionaliting of the compressor.

Do not excessively stuff foods so as to ensure proper air circulation.

Defrost the appliance in case there is ice to facilitate the transfer of cold.

In case of absence of electrical energy, it is advisable to keep the refrigerator door closed.

Open or keep the doors of the appliance open as little as possible

Avoid adjusting the setting to temperatures too cold.

Remove dust present on the rear of the appliance

Before first use

You must allow the fridge to settle for at least four hours prior to switching the
power on.
It is recommended that you clean the interior of the appliance prior to first use, using a
solution of bicarbonate of soda and warm water and then thoroughly drying the interior.
The fridge may have an odor to it at first use. This will disappear as the appliance cools.
Please note:
The appliance will start 5℃ for fridge and -18℃ for freezer and work continuously until it
comes down to the correct temperature. If the appliance is switched off, you should allow
five minutes before switching it on again to prevent unnecessary damage to the
compressor. Never store inflammable or explosive items and strong corrosive acids or
alkalis in the appliance. This fridge cools your food by making the inside back of the cavity
cold. It is normal for frost to build up on this surface; it then dissipates and drains through
a small drain at the bottom, where it evaporates harmlessly. The presence of frosting at
the back is not a malfunction of the fridge.
mark on this product, we are confirming compliance to all relevant European
15