Vingtor Stentofon EAM-200 Quick Start Manual

Vingtor Stentofon EAM-200 Quick Start Manual

Replacing amplifier module on ena2200

Advertisement

Replacing Amplifier Module on ENA2200

Item Number
Item Name
102 3922 200
EAM-200

Accessing the Old Amplifier Module

1
Before you start the procedure:
1. Switch off and disconnect the amplifier from the power mains
2. Remove the top cover by unscrewing the 8 Torx screws using a T10 bit
Description
Exigo 2x200 Watt Amplifier Module for ENA2200
When the top cover is removed, you will see the Amplifier
Module located at the side of the amplifier cabinet.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EAM-200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vingtor Stentofon EAM-200

  • Page 1 Replacing Amplifier Module on ENA2200 Item Number Item Name Description 102 3922 200 EAM-200 Exigo 2x200 Watt Amplifier Module for ENA2200 Accessing the Old Amplifier Module Before you start the procedure: 1. Switch off and disconnect the amplifier from the power mains 2.
  • Page 2 Demounting the Old Amplifier Module The Amplifier Module is plugged into the Euroconnector at the bottom of the cabinet and secured with four M4 screws as shown: To demount the Amplifier Module: 1. Use a PZ2 bit to unfasten and remove the four M4 screws 2.

This manual is also suitable for:

102 3922 200

Table of Contents