Safety Belt Reminder Light - Buick 2006 Rendezvous Owner's Manual

Retro-Active Reset
The trip odometer has a feature called retro-active
reset. This feature can be used to set the trip odometer
to the number of miles or kilometers driven since the
ignition was last turned on. This can be used if you
forget to reset your trip odometer at the beginning of a
trip. To use the retro-active reset feature, push and
hold the trip/reset button for at least five seconds. The
trip odometer will then display the number of miles
or kilometers driven since the ignition was last turned
on and you began driving. If you use the retro-active
reset feature after you have started the vehicle,
but before you begin moving, the display will show
the number of miles or kilometers you drove during
the last ignition cycle. Once you begin driving, the
trip odometer will accumulate mileage. For example,
if you have driven 5.0 miles (8.0 km) since you started
your vehicle, and then activate the retro-active reset
feature, the display will show 5.0 miles (8.0 km).
As you drive, the display will then increase to
5.1 miles (8.2 km), 5.2 miles (8.4 km), etc.
3-40
Tachometer

Safety Belt Reminder Light

When the key is turned to ON or START, a chime will
come on for several seconds to remind people to fasten
their safety belts.
The tachometer
displays the engine
speed in revolutions
per minute (rpm).
The safety belt light will
also come on and stay on
for several seconds. If
the driver's belt is already
buckled, neither the
chime nor the light will
come on.