Page 3
The MonoMatik 3 softener A water safety device (1) must be used in order for the MonoMatik 3 may only be operated as described in these operating instructions.
Maintenance by service technicians to the on-site water drain. Attach a hose to the side Have the MonoMatik 3 examined at least once per year by an au- safety overflow and guide thorised Winterhalter service technician. The inside of the container this to the on-site water drain.
7.4 Check backflow preventer type HD (1) water stop cock (2) dirt trap (3) backflow preventer (4) hose Close the water stop cock (1). Install the backflow preventer (3) according to the drawing. Keep the hose (4) above the level of the backflow preventer (3). ...
Items at Pos. 1 to 4 and Pos. 6 are not part of the MonoMatik 3 installation kit A water safety device (4) must be used in order for the MonoMatik 3 to be operated in accordance with DIN requirements.
6 mm. Switch off the warewasher connected to the MonoMatik 3. Open the water supply to the MonoMatik 3 slowly. Remove the sticker on the screw (1).
Page 8
Each tooth deviation relates to approx. 20 litres of soft From serial no. 102847 water more or less up until the next regeneration. Total hardness Start up the warewasher connected to the MonoMatik 3. in °dH Fill up the warewasher. Setting value ...
Need help?
Do you have a question about the MonoMatik 3 and is the answer not in the manual?
Questions and answers