Advertisement
S317 Fiber Cleaver Operating Manual
Please read this manual carefully before use.
1. The Fitel S317 fiber cleaver is a precision machine. It cannot withstand strong impact, as this will affect the
performance of the cleaver.
2. Fiber and fiber optic debris are very thin and sharp pieces of glass. When using the cleaver, please wear protective
safety equipment to prevent fiber optic debris from entering the skin or eyes. Please use a designated waste
receptacle to collect fiber optic debris.
3. Do not touch the blade with your hands. Do not touch the blade during maintenance.
4. Please do not disassemble the cutter to use oil. If you need to repair, please contact your local representative.
1. Specifications
Applicable fiber
Coating diameter
cladding diameter
Cleaving length
Dimensions
Weight
Life of the blade
2. Appearance
Lever
Holder
Silica
φ0.25、φ0.9、φ2.0、φ3.0、3×2
125μm
5~16mm(φ0.25)；10~16mm(φ0.9)
93mm(W)×86mm(D) ×63mm(H)
380g
Typical 48,000 fibers
Slider
Lid
Fiber clamp
Waste box
FTS-B607-1
Advertisement
Table of Contents
Related Manuals for Fitel FTS-B607-1
Summary of Contents for Fitel FTS-B607-1
- Page 1 S317 Fiber Cleaver Operating Manual Please read this manual carefully before use. 1. The Fitel S317 fiber cleaver is a precision machine. It cannot withstand strong impact, as this will affect the performance of the cleaver. 2. Fiber and fiber optic debris are very thin and sharp pieces of glass. When using the cleaver, please wear protective safety equipment to prevent fiber optic debris from entering the skin or eyes.
- Page 2 3. Steps Please lift the lever, open the body lid of the cleaver, and make sure that the slider is in front of you. Use a stripper to strip 20-30 mm of the optical fiber's coating, then clean the optical fiber with a fiber wipe dipped in alcohol and wipe it clean.
- Page 3 5. Blade recycling The blade is a regular circle. Any point on the circle can cut more than 1000 times. Therefore, the area between 1 ~ 16 can be selected to cut. When all area is used up, the height of the blade can be adjusted to a higher position, and it is possible to use it repeatedly.
- Page 4 ページ指定：3,4,3,4,5,6,5,6 ページ設定 原稿サイズ：Ａ４ 出力用紙サイズ：Ａ４ 印刷の向き：縦 ページレイアウト：４ページ／枚 配置順：左上→右上→左下→右下 仕上げ 印刷方法：両面印刷 とじ方向：長辺とじ（左開き／上開き） 給紙 Ａ４...
Need help?
Do you have a question about the FTS-B607-1 and is the answer not in the manual?
Questions and answers