Page 1
Digital Kitchen Scale Model: EK9000 User Manual Questions or Concerns? Mon–Fri, 9:00 am–5:00 pm PST/PDT support@etekcity.com • (855) 686-3835...
Page 2
Thank you for purchasing the Digital Kitchen Scale by Etekcity. If you have any questions or concerns, please reach out to our helpful Customer Support Team at support@etekcity.com. We hope you enjoy your new kitchen scale!
Table of Contents Package Contents Specifications Important Safety Information Function Diagram Display Diagram Before First Use Using Your Scale Replacing the Batteries Troubleshooting Warranty Information Customer Support Package Contents 1 x Digital Kitchen Scale 2 x 1.5V AAA Batteries (Pre-Installed) 1 x Quick Start Guide...
Specifications Weight Capacity 176 oz / 11 lb / 5000 g / 5000 mL oz / lb:oz / g / mL (water/milk) / fl’oz Units (water/milk) Auto-Off 120 seconds 2 x 1.5V AAA Batteries Battery (Pre-Installed) Dimensions 8.1 x 6.5 x 1.3 in / 207 x 166 x 34 mm Increments Measurement Unit Item Weight...
READ AND SAVE THESE INSTRUCTIONS Important Safety Information To avoid damage to this scale, please read and follow all instructions and safety guidelines in this manual. Scale • Do not exceed the 11 lb / 5000 g weight capacity, as this will damage the scale.
Page 6
Batteries • Do not mix new and old batteries. • If the low battery indicator (“Lo”) appears on the display, replace the batteries. • If the scale is not in use for an extended period of time, remove the batteries to conserve battery life and extend the lifetime of the scale.
Before First Use The batteries are pre-installed in the scale. Open the battery compartment on the underside of the scale. Remove the plastic strip from the battery compartment. [Figure 1.1] Replace the battery compartment cover. Turn the scale over again and place on a hard, dry, flat surface. Press to turn on the scale.
Using Your Scale Note: • For accurate results, always place the scale on a hard, dry, flat surface, and keep the scale away from dirt, dust, vibrations, wind, air currents, and electromagnetic interference. • When you turn on the scale, choose units, or use the Tare function, wait for the display to read “0.00”...
Page 11
Zero / Tare Function When you measure items inside a container, you can use the Tare function to remove the container’s weight from the final measurement. Press to turn on the scale. Make sure the display reads TARE “0.00”. If the screen does not display “0.00” automatically, press to auto-adjust to zero.
Unit Conversion To change the unit of measurement, press UNIT until the display shows the desired unit of measurement. Automatic Power Off To save battery power, the scale will automatically power off after 120 seconds of inactivity. Manual Power Off Press and hold for 2 seconds to turn off the scale.
Troubleshooting Problem Possible Solution Open the battery compartment and remove the plastic strip. Scale does not turn on. Replace the batteries (see page 12). Make sure the batteries are inserted under the correct polarity as marked in the battery compartment. Place the scale on a hard, dry, flat surface, and keep the scale away from dirt, dust, vibrations, wind, air currents, and electromagnetic interference.
Page 14
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. ...
2 years from the date of original purchase. Etekcity agrees, at our option during the warranty period, to repair any defect in material or workmanship or furnish an equal product in exchange without charge, subject to verification of the defect or malfunction and proof of the date of purchase.
Page 16
This warranty does not extend to products purchased from unauthorized sellers. Etekcity’s warranty extends only to products purchased from authorized sellers that are subject to Etekcity’s quality controls and have agreed to follow its quality controls. All implied warranties are limited to the period of this limited warranty.
Customer Support If you have any questions or concerns about your new product, please contact our helpful Customer Support Team. Etekcity Corporation 1202 N. Miller St., Suite A Anaheim, CA 92806 Email: support@etekcity.com Toll-Free: (855) 686-3835 Support Hours Mon–Fri, 9:00 am–5:00 pm PST/PDT *Please have your order invoice and order ID ready before contacting Customer Support.
Page 18
Connect with us @Etekcity CA040921AL-M1_0321EK9000...
Need help?
Do you have a question about the EK9000 and is the answer not in the manual?
Questions and answers