AEG A83400HLW0 User Manual page 13

Problem
Power indicator light is flash-
ing.
The lid doesn't close com-
pletely.
The lid is difficult to open.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Possible cause
The lid has been left open
for a long time.
An error has occurred in
measuring the temperature
or the appliance is not work-
ing properly.
Food packages are blocking
the lid.
There is excessive frost.
The lid gaskets are dirty or
sticky.
The valve is blocked.
Temperature is set incorrect-
ly.
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is too
high.
Food placed in the appli-
ance was too warm.
The lid is not closed proper-
ly.
The FROSTMATIC function
is switched on.
The lid is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is
not correctly positioned.
Temperature is set incorrect-
ly.
This is normal, no error has
occurred.
ENGLISH
Solution
Open the lid only if necessa-
ry.
Contact the nearest Author-
ized Service Centre.
Arrange the packages in the
right way, see the sticker in
the appliance.
Eliminate excess frost.
Clean the lid gaskets.
Check the valve.
Refer to "Operation" chap-
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food to cool to room
temperature before storing.
Check if the lid closes well
and the gaskets are undam-
aged and clean.
Refer to "FROSTMATIC
function".
Refer to "Opening and clos-
ing the lid".
Position the water drainage
plug in the correct way.
Refer to "Operation" chap-
ter.
The compressor starts after a
period of time.
13