While Driving - BMW 2006 7 Series Owner's Manual

Maintaining speed, storing, and
decelerating
Pull the lever, arrow 2:
Functions in the same way as 1, except that the
vehicle speed is decreased.
Interrupting the cruise control
Briefly press the lever up or down, arrow 3.
In addition, cruise control is interrupted auto-
matically:
> when you apply pressure to the brake pedal
>
when you shift the automatic transmission
into position N
> when the DSC control is operative
Resuming stored speed
Briefly press the button 4:
The vehicle accelerates back to and maintains
the stored speed.
Displays in speedometer
5 Pointer for stored speed
> Cruise control activated
> Cruise control deactivated
6 Mark for stored desired speed in the multi-
level function
Storing desired speeds
With vehicle stationary
1. Switch on the ignition.
2. Press, arrow 1, or pull, arrow 2, the lever
past the resistance point:
Now you can move the pointer 5 with the
68
Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG
lever until you have reached your desired
speed:
> Press or pull the lever up to the resis-
tance point again: the pointer slowly
moves.
> Press or pull the lever past the resis-
tance point again: the pointer jumps to
the next multiple of 5 mph or 10 km/h
and then further, as long as the lever is
held.
3. Press the button 4 for approx. 3 seconds.
The stored desired speed is indicated by a
mark 6.
If six desired speeds have already been stored,
please delete at least one of them before adding
another.

While driving

1. Press, arrow 1, or pull, arrow 2, the lever
past the resistance point.
2. Press the button 4 for approx. 3 seconds.
The current speed is applied as the desired
speed and displayed with 6.
If all of the marks 6 flash twice, this indicates
that six desired speeds have already been
stored. You must then delete at least one of
them before adding another.
Deleting desired speeds
1. Select corresponding desired speed 6,
refer to section below.
2. Press button 4 for approx. 3 seconds.
Activating multilevel preset mode
Press, arrow 1, or pull, arrow 2, the lever past
the resistance point.
The current driving speed is maintained, stored
and displayed by the pointer 5.
Selecting desired speed
Press, arrow 1, or pull, arrow 2, the lever past
the resistance point:
The next desired speed is selected.