Acura 2009 MDX Owner's Manual page 281

Main Menu
If you are training the second or third buttons, go directly to step 1.
Training a Button
1
Position the remote transmitter you
wish to link 1-3 inches from the
HomeLink button you want to program.
2
Press and hold the desired HomeLink
button and the button on the remote
transmitter you wish to link.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
NO
a
Press and hold the button on the
remote and the HomeLink button at
the same time. Then, while
continuing to hold the HomeLink
button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
NO
Table Of Contents
3
Press and hold the programmed
Homelink button for about a
second.
Does the device (garage door opener) work?
NO
4
Press and hold the
HomeLink button
again.
HomeLink
HomeLink indicator
LED is on.
flashes for 2 seconds,
then remains on.
a
The remote has a rolling code.
YES
Press the "learn" button on the
remotely controlled device
(e.g., garage door opener).
b
Within 30 seconds, press and hold
the programmed HomeLink button
for 2 seconds.
5
Press the programmed HomeLink
button again; the remotely
controlled device should operate.
YES
2009 MDX
HomeLink
Retraining a Button
1
Press and hold the desired
HomeLink button until the HomeLink
indicator begins to flash slowly.
YES
Indicator remains
Training
on for about 25
seconds (standard
complete
transmitter)
2
When the indicator begins to flash
slowly, continue to hold the HomeLink
button and follow steps 1-3 under
Training a Button.
Erasing Codes
To erase codes stored in all buttons, press
and hold the two outer buttons until the
HomeLink indicator begins to flash (about
10 to 20 seconds), then release the buttons.
You should erase all three codes before
selling the vehicle.
If you have any problems programming
HomeLink, see the owner's manual included with
the device you are trying to program, or call
HomeLink at 1-800-355-3515 or go online to
www.homelink.com.
Universal Transceiver
®
Indicator flashes rapidly
for 2 seconds, then
remains on for about 23
seconds (rolling code
transmitter)
CONTINUED
277