Page 2
Supplied Accessories • Ear chip • Ear hook • USB Cable* • Operation Manual (This Manual) *USB cable is designed to charge this product. Do not use it with other products. Specifications Communication System: Bluetooth specification Ver 4.1 Output: Bluetooth specification Power Class 2 Compatible Bluetooth Profiles: HSP/HFP Dimensions: 60mm (W) x 15.2mm (H) x 22mm (D)
Page 3
Safety Precautions (Be Sure to Read) Do not use this product while riding a bicycle or driving a car. Accidents can result. For hands-free operation, use the transceiver VOX function. Do not charge the battery in a hot location such as near a heater or un- der the sun.
Page 4
• Turn down the volume To temporarily mute the TX audio while the paired transceiver is operating in VOX function, disable the SSM-BT10 microphone by pressing VOL (+) and VOL (-) simultaneously. Press VOL (+) and VOL (-) simultaneously to enable the microphone again.
Page 5
USB charging adapter USB Cable (supplied) Caution USB jack • Charge completely in 3 hours. • The SSM-BT10 cannot be used while charging. • Charging for more than the RED: Charging specified time may degrade the BLUE: Charge Complete built-in battery.
Page 6
It is necessary to register (pair) this product to the transceiver. Before it will operate with it. 1 Press and hold for 3 seconds Pair the “SSM-BT10” with to turn ON the connected radio. For the pairing procedure, Blinks red...
Page 7
(illustration Blue Connected on the left. Go to “How to communicate” (page 6). Caution The SSM-BT10 is designed for YAESU Bluetooth compatible transceiv- ers. Operation with other Bluetooth compatible devices (such as smart- phones and PCs) is not guaranteed.
Page 8
When no voice is detected, the will automatically switch to earphone will beep and the trans- TX. Continue speaking in ceiver will return to RX mode. a normal voice to transmit. 4 Press and hold the multifunction button for 5 seconds, to turn SSM-BT10 OFF.
Page 9
Press again briefly to return to receive. beep! Caution Be sure to press the multi function button when you finish talking. If you forget to press it, transmission will continue. Press and hold the multifunction button for 5 seconds, to turn SSM-BT10 OFF.
Page 10
List of typical operations Do this Announce/Beep Press and hold the [MFB] Blinks RED and Turn ON. Power ON for 3 seconds. Blue Press and hold the [MFB] Turn OFF. Glow RED Power OFF for 5 seconds. 1. P r e s s a n d h o l d t h e Blinks RED and Connect with [MFB] for 3 seconds.
Page 11
Maximum volume. (At maximum volume) Minimum volume. (At minimum volume) Disable the SSM- Press VOL (+) and VOL (-) Mute ON BT10 Microphone. simultaneously. Enable the SSM- Press VOL (+) and VOL (-) Mute OFF BT10 Microphone. simultaneously again. Automatic trans- S p e a k i n t o t h e m i c r o - mission by VOX (At the start of trans-...
Page 12
Receive by [MFB]. Press the [MFB] again. (At the end of trans- mission) Battery Low level Blinks RED Battery Low warning. Power OFF due to Automatically turns OFF. voltage drop. Connect to the charger Battery Charge. with the supplied USB Glow RED cable.
Page 24
YAESU MUSEN CO., LTD. Tennozu Parkside Building 2-5-8 Higashi-Shinagawa, Shinagawa-ku, Tokyo 140-0002 Japan YAESU USA 6125 Phyllis Drive, Cypress, CA 90630, U.S.A. EBB77X700 (1904I-AC) YAESU UK Unit 12, Sun Valley Business Park, Winnall Close 八重洲無線株式会社 Winchester, Hampshire, SO23 0LB, U.K.