Subscribe to Our Youtube Channel
Related Manuals for Extreme Home Arcades CT101
Summary of Contents for Extreme Home Arcades CT101
- Page 1 Extreme HOSTAGE TARGET Model Number: CT101 Safety / Set-up / Use Patent Pending Document Revision 9/5/2011...
-
Page 2: Table Of Contents
Page 2 Table of Contents Safety guidelines Page 3 Target overview Page 4 Locating your target Page 5 Rocker Installation Page 6 Target Construction Page 7 Target Installation Page 8 Position Rocker on Base Page 9 Stop Stick Installation Page 10 Warrantee Page 11... -
Page 3: Safety Guidelines
Page 3 Warning Failure to read, understand, and follow the enclosed information prior to the use of our products greatly increases the risk of injury or death. You should read and fully understand the enclosed instructions prior to using our products. Safety Guidelines General Safety Rules Treat all firearms as though they are loaded. -
Page 4: Target Overview
Page 4 Target Overview Major Components 1) Post Shim 2) Wood Furring Strip- moving (not included) 3) Rocker Assembly 4) Back Stop 5) Wood Furring Strips- stationary (not included) 6) Left & Right Barrier Bracket 7) Level Feet 8) Brake Tab 9) Base Assembly Note: Your target system is made from high quality,... -
Page 5: Locating Your Target
Page 5 Selecting the Location for your Targets Always know what is in front and behind your target. Determine that you have a safe backstop or background! Your Hostage Target comes equipped with four Level Feet which can be used for leveling the target on uneven terrain. It is best however, if you select the most level terrain possible for placement of the target. -
Page 6: Rocker Installation
Page 6 Rocker Installation Step 1 Set Rocker Assembly on Base as shown. Rocker Side Plate should be centered in groove of track. Center side plate in track. -
Page 7: Target Construction
Page 7 Target Construction All targets should be mounted using standard wood 1x2 furring strips cut to 48” length. Moving Target - the moving target is weight sensitive and only single wall corrugated material should be used. Standard USPA / IPSC targets work well with no modification required. -
Page 8: Target Installation
Page 8 Target Installation Install stationary hostage furring strips into barrier bracket tubes. Bend spring tabs if needed to achieve a Moving Steps tight fit. threat Install post shim Stationary hostage target Install moving threat target furring strips furring Tighten hand knobs strip Post Hand knobs... -
Page 9: Position Rocker On Base
Page 9 Position Rocker on Base Step 1 Slide Rocker Assembly left or right in track as needed until rocker hole and track screw are in-line when rocker is tilted as shown. Tilt Rocker Hole Step 2 Adjust Level Feet up or down as needed until threat target is concealed. -
Page 10: Stop Stick Installation
Page 10 Stop Stick Installation Step 1 Step 2 Tilt Rocker completely left until it bumps against the stop stick then release. Install stop sticks as shown. Rocker should return to vertical position. Tilt Rocker completely right until it These stops will prevent Rocker stops against the stop stick then release. -
Page 11: Warrantee
• A product damaged by bullet strikes . (No portion of the CT101 system is built to withstand bullet strikes) • A product that has been modified or altered by anyone other than an authorized Challenge Targets repair technician. - Page 12 1-800-859-5841 www.challengetargets.com P.O. Box 75040 Fort Thomas, KY 41075...
Need help?
Do you have a question about the CT101 and is the answer not in the manual?
Questions and answers