Optional Adaptors - Sony FWD-32LX2F Operating Instructions (Base Model) Operating Instructions Manual
Flat wide display monitor
Hide thumbs
Also See for FWD-32LX2F Operating Instructions (Base Model):
- Protocol manual (28 pages) ,
- Brochure & specs (12 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Available languages
Available languages
Optional Adaptors
The connectors marked with 5 and 7 on the side
panel are slot-in types and can be fitted with any of the
following optional adaptors (not supplied).
For details on installation, consult your Sony dealers.
VIDEO INPUT Adaptor BKM-FW10
This is the same as the optional adaptor preinstalled in
the 7 OPTION 2 slot. See page 8.
COMPONENT/RGB INPUT Adaptor BKM-
FW11
1
2
3
1 Y/G P
/C
/B P
/C
/R IN (BNC): Connects to
B
B
R
R
the analog RGB signal or component signal output
of a piece of video equipment or PC.
2 HD VD IN (BNC): Connects to the
synchronization signal output of a PC.
Note
When inputting a component signal, be sure not to input sync
signals to the HD and VD connectors. If you do so, the
picture may not be displayed properly.
3 AUDIO (Stereo mini jack): Inputs an audio
signal. Connects to the audio output of a piece of
video equipment or PC.
RGB/COMPONENT ACTIVE THROUGH
Adaptor BKM-FW12
1
2
3
1 RGB/COMPONENT IN (D-sub 15-pin):
Connects to the component signal output or
analog RGB signal output of a piece of video
equipment or PC. For details on inputting a
component signal to the connector, see “Pin
assignment” on page 35.
Note
When inputting a component signal, be sure not to input sync
signals to pins 13 and 14. If you do so, the picture may not be
displayed properly.
2 RGB/COMPONENT OUT (D-sub 15-pin):
Connects to the component signal input or analog
RGB signal input of a piece of video equipment or
PC.
3 AUDIO IN (Stereo mini jack):
Inputs an audio signal. Connects to the audio
signal output of a piece of video equipment or PC.
Note
When the display is not connected to an AC power or is in
the standby mode, no signal is output from the RGB/
COMPONENT OUT.
NETWORK MANAGEMENT Adaptor BKM-FW32
For details, see the instruction manual of the BKM-
FW32.
STREAMING RECEIVER Adaptor BKM-FW50
For details, see the instruction manual of the BKM-
FW50.
Note
When using a network cable for the BKM-FW32/50, be sure
to use a shielded cable to help prevent the radiation of
undesired radio waves. For details on the connection, see
each instruction manual.
For details on the optional adaptors for system
expansion, BKM-FW series, see each instruction
manual.
Page 10
Hide quick links:
Advertisement
Chapters
Table of Contents
