MAG TOOLS MB89UCL Assembly Instructions

ASSEMBLY INSTRUCTIONS
To simplify the assembly process, finger tighten all bolts until all bolts are in place.
Once all bolts are in place, you can then final tighten.
1. Carefully lay bottom tray of utility cart on a clean work surface.
2. Take four legs with bumpers and bolt them to the bottom tray using the Torx bolts (A). Legs are labeled
BL(back left), BR(back right), FL( front left) and FR(front right).
3. If you do not have an add-on drawer unit (MB89UCAD33, MB89UCAD36, or MB89UCAD6) proceed with
bolting top tray in place and finger tighten all bolts. Remove the tie straps from legs and bumpers. Attach torx
bolts to center holes of legs using spring washers, flat washers, and nuts.
If you have an add-on drawer unit (MB89UCAD33, MB89UCAD36, or MB89UCAD6), do not install the top
front bolt on the FL and FR legs. Leave the side bolts on the FL and FR legs loose. Remove the tie straps
from legs and bumpers. The next step is mount the prybar holders which are labeled left and right. Mount
the left prybar holder to the inside of the left legs using the holes near the center of the legs. Mount the
right prybar holder to the inside of the right legs using the holes near the center of the legs. Secure using
Torx bolts, flat washers, spring washers, and hex nuts; this hardware comes with the drawer unit along
with a separate assembly sheet. Remove the keys from the drawer unit. The drawer unit will now slide in
the front of the cart and rest on the prybar holders. Align holes in top of drawer unit with holes in top
tray and secure using hex bolts and flat washers. Secure the bottom of the drawer unit to the prybar
holders using hex bolts and flat washers. Now tighten side bolts and front bolts of the legs.
4. Determine which side the cart handle will be on. Remove the lower side bolts from the front and back legs.
Mount handle and tighten bolts. You can now final tighten all bolts.
WARNING: Make sure the lid is locked.
5. Using handle, roll cart forward onto the opposite side. Mount casters using hex bolts, spring washers,
and flat washers.
NOTE: It is recommended that the locking casters go onto the same side as the handle.
6. Roll cart upright onto casters.
7. Install divider in bottom tray if desired.
MB89UCL, -BK, -BL, -YE, -LG, -OR, -PP, -GRAY
mB89UCL, -Bk, -BL, -yE, -LG, -OR, -PP, -GRay
Copyright © Professional Tool Products, 2009
1
Utility Cart w/ Locking Lid
All rights reserved.
Rev. 08/21/09