After-Cleaning Care - Bissell СrossWave X7 Cordless Pet Pro 3011 Series User Manual

After-Cleaning Care

Go to support.BISSELL.com for a full list of how-to videos.
1.
Place the machine on the
3-in-1 Docking Station. Make
sure the solution in the clean
water tank reaches the Clean
Out Cycle line. If it does not, fill
tank with water to that line.
Note: For best results, run the
Clean Out Cycle no more than
two times after each cleaning
session.
4a.
For easy brush roll drying,
release the brush roll window
by pressing the button on the
top of the foot and resting the
brush roll window on the 3-in-1
Docking Station.
6.
Empty the dirty water tank.
To remove, press the button on
the top of the tank, grab the
front handle and pull tank out.
WARNING
electrical outlet before performing maintenance or troubleshooting on the dock.
2.
Empty the dirty water tank
prior to starting the Clean Out
Cycle.
4b.
Or, remove the brush
roll by pressing the button to
release the brush roll window.
Pull the brush roll tab to
remove and put the brush in
the drying tray. The brush and
window can be hand washed.
7.
Remove the top of the tank
by grabbing the sides of the
filter and pulling up.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
3.
Push the Clean Out Cycle
Button to start the 40-second
cycle.
5.
Remove the machine from
the dock and wipe out the tray.
Do NOT rinse under faucet.
This keeps water out of the
charging plug.
4.
Pull strainer tab up and out
of the tank to separate hair
and debris from dirty water.
Throw debris into the trash.
CONTINUED ON NEXT PAGE
BISSELL.com 9