TECHWOOD TCG-2016 Instruction Manual page 8

1. CARRY HANDLE
2. REAR AIR ENTRY
3. FRONT OUT AIR GRID
4. HOUSING
5. SELECTOR 0 / COLD / 1000W / 2000W
6. SAFETY TIP OVER SWITCH
7. PILOT LAMP
8. ADJUSTABLE THERMOSTAT
 Unroll the power cord completely.
 Check that the tension in force in the country where you are corresponds to
that indicated on the apparatus.
 Connect the apparatus in a socket-outlet in good state, to avoid any danger.
 Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
 Stand the appliance on a table or flat surface.
1. Turn switch to the "O" position (see picture).
2. Plug in the appliance, and turn the heat select switch to choose cold air or
warm air and the temperature of warm air as below.
3. With the thermostat knob, select the desired room temperature.
4. Note: We recommend to turn the thermostat button on half possibilities and
complete the setting after a while.
5. After use, Turn the dial to "0"
6. Disconnect the appliance by removing the plug from the wall outlet. (Never pull
the cord or on the unit).
7. While working the indicator light will be on.
Turn the switch to " " position, the heater blows cool air.
1. Turn the switch to "I" position, the heater blows warm air, working at 1000W.
2. Turn the switch to "II" position, the heater blows warm air, working at 2000W.
3. Turn the switch to "O" position, the heater stops working, the indicator light will
be off.
FEATURES
USE
8