DIAGRAM OF THE COMPONENTS
1. Upper cap
2. Salt and pepper buttons
3. Motor housing and
6 «AAA» battery compartment (batteries not included)
4. Clear chamber
5. Ceramic grinder
6. Adjusting nut
7. Bottom cover (dual functions: a mess-free bottom lid
and a filling funnel)
DUAL FUNCTION BOTTOM COVER
Function 1:
Mess free bottom
lid on table
1. To remove upper cap, turn the upper cap anti-clockwise and lift
upwards.
2. Lift off the power unit and install 6 x AAA batteries into the battery
compartment.
3. Do not leave discharged batteries in the mill. Always replace all
4 batteries at the same time.
NOTE: Heavy duty alkaline batteries are recommended. Ensure the «+»
and «2 are aligned.
Function 2:.
Filling funnel.
when you run the mill.
BATTERY INSTALLATION
Note:
remove
the bottom cover
EN
3