Table of Contents
Advertisement
Quick Links
Device Overview
Pull to Pair Tab
Getting Started
Powering Up and Pairing
1. Pull and remove the "Pull to Pair" tab from the
Micro Door Sensor. The device will power up and
begin searching for a ZigBee network to join.
2. Initiate pairing on the home gateway/hub.
3. The Micro Door Sensor should start the joining
process automatically. While the sensor is
searching for a network, the status LED will
periodically blink blue.
Once the Micro Door Sensor has successfully
joined the network, the status LED will turn solid
blue for 2 seconds, then turn off.
4. Finish pairing setup from your home gateway/hub.
Micro Door Sensor
QUICK START GUIDE
Magnet
Status LED
LED Light Patterns
Pattern
Blue | Blinking
Green | Short
Red | Blinking then
White | Solid
Red | 3 Blink Series
SmartThings
Cover Removed
Reset Button
Description
Establishing Connect /
Joining
Joining Successful
Power Outage /
Emergency Lighting
Low Battery
3321
CR-2450 Battery
Advertisement
Table of Contents
Related Manuals for SmartThings T3L-SS013
Summary of Contents for SmartThings T3L-SS013
- Page 1 SmartThings Micro Door Sensor QUICK START GUIDE 3321 Device Overview Magnet Cover Removed Status LED CR-2450 Battery Pull to Pair Tab Reset Button Getting Started LED Light Patterns Powering Up and Pairing Pattern Description 1. Pull and remove the “Pull to Pair” tab from the...
- Page 2 Corp could void the user’s authority to operate the equipment. Conforms to FCC Part 15B Le présent appareil est conforme aux CNR d’Industrie Canada FCC ID: T3L-SS013 applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas IC ID: 12192A-SS013 produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout...
Need help?
Do you have a question about the T3L-SS013 and is the answer not in the manual?
Questions and answers