SmartThings STS-IRM-250 Quick Start Manual

Template for wall mounting:
Wall
Plate
Motion Sensor components
Motion Sensor
Wall Plate
Quick-Start
Guide
Motion Sensor
If your device doesn't connect
If your device doesn't connect when you remove the pull-tab,
hold the "Connect" button for 5 seconds and release it when
the LED light starts blinking red, then tap "Connect New
Device" under Marketplace in the SmartThings app.
Note: If you don't release the "Connect" button when the LED
light starts blinking red, the device will not be able to
complete the connection.
LED Light
CR2477
Connect Button
Meet your Motion Sensor
The Motion Sensor lets you know when movement is
detected in a certain area and can trigger different actions
in response to that movement (or lack of movement).
Using the Motion Sensor:
You'll want to place your Motion Sensor so that the circular
sensor is facing the area that you'd like to monitor. Be sure
that no objects are directly blocking the Sensor's line of
detection. By angling the sensor downward, it will be able to
detect movement of pets. By angling it upward or by placing
it flat in elevated area, it won't detect the movement of pets.
How to connect a Motion Sensor
Select "Connect New Device" in the free SmartThings
mobile app and then remove the "Remove to pair" tab found
in the Motion Sensor.
Installation Tips
The Motion Sensor works best if it's within 15 feet (4.5
meters) of the SmartThings Hub when you connect it.
Replacing the battery
To replace the battery in your Motion Sensor, use a flat tool
to carefully remove the battery from the device. Then add a
new battery and close the cover back into place.
Cover
CR2477
Bottom
USE CARE when
replacing the battery
to avoid damaging
the device.