Hitachi CP-X807W Service Manual page 43

Wiring of the power supply block
Wiring of the power supply block
(1) Pass the CNPW1, CNPW2, TSW and CNFG2 through the wiring clamp of power supply case.
Do not make excessive length of the cables. Make sure not to touch the primary.
(2) Attach the FEB1 to the CNPW1 and CNPW2.
(3) Attach the FEB1 to the upper surface of power supply case with cable tie.
(4) Bundle the CNPW1, CNPW2, TSW and CNFG2 with clamp.
(5) Attach the CNFG2 to the power supply case with screw.
(6) Pass the CNAC through the incision of insulation seat.
about 90
degrees
Incision of
Insulation seat
Area of Importance
Wiring clamp
Wiring diagram 3
Attach the FEB1(ferrite core) to CNPW1 and CNPW2.
Make sure to completely lock the hook when attaching the FEB1.
Area of Importance
Attach the FEB1 to the Network unit with cable tie (#2730).
Cut the excessive length of cable tie.
Power supply case cable tie