Cleaning And Care; Safety Notice - lamart BAMBOO LT7024 Product Information And Instructions

■ "ZERO" OR "TARE" FUNCTION
To weigh diff erent loads consecutively without removing loads from the scale.
Put fi rst Load on the scale, get weight reading. Press
■ Condition 1: "ZERO" function
When total sum of all loads on scale
scale's max. weight capacity.
(4%=80g when capacity is 2000g;
200g when capacity is 5000g)
LCD will show --------- or 0g each time
--------- means not stable, please wait for a moment.
0g and meanwhile an icon o on the left side of LCD
mean ZERO function is activated. Max. weight capacity
remains unchanged.
■ AUTO SHUT OFF
Auto shut-off occurs if display shows '0' or shows the same weight reading for 2 minutes.
■ MANUAL SHUT OFF
To maximize battery life, always press
Note: when display shows "0", press
■ WARNING INDICATORS
1. Replace new battery.
2. Scale overload. Remove item to avoid damage. Max. weight capacity is indicated on the scale.
■ Battery Advice
• If the scale is not to be used for
long periods, it's recommended
to remove the battery to avoid
damage to the scale due to
possible battery leakage.
• Keep the batteries out of reach
of children.
Waste electrical products should not be disposed of with houeshold waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.

CLEANING AND CARE

1. Clean the scale with a slightly damp cloth. DO NOT Immerse the scale in water or use chemical/abrasive cleaning agents.
2. All plastic parts should be cleaned immediately after contact with fats, spices, vinegar and strongly fl avored/colored foods. Avoid contact with acids citrus juices.
3. Always use the scale on a hard, fl at surface. DO NOT use on carpet.

SAFETY NOTICE

Do not use coarse or aggressive cleaning agents – this can damage the surface (e.g. caustic pipe cleaning agents).
Negligent handling may lead to surface damage (chipping). These defects are the result of improper use and do not constitute a product defect. We recommend that it is always cleaned by hand using
non-aggressive cleaning agents and fi ne towels or sponges. Must not be used in a dishwasher.
button to reset the LCD reading to "0" before adding next load. You can repeat this operation.
4% of
is perssed.
again to turn off the scale after using.
to turn off the scale;
when display shows weight reading, press
■ Condition 2: "TARE" function
■ Under this condition:
for 3 seconds to turn off the scale.
• Do not mix old and new batter-
ies, with diff erent compositions
or of diff erent brands in order
to prevent possible leakage,
explosion.
• Do not heat or deform the
batteries or explore to fi re.
When total sum of all loads on scale > 4% of scale's max. weight
capacity.
(4%=80g when capacity is 2000g;
200g when capacity is 5000g)
LCD will show --------- or 0g each time
means not stable, please wait for a moment. 0g and meanwhile
an icon TARE on upper left corner of LCD mean TARE function is
activated. Max. Weight capacity is reduced by total weight of all
loads.
By pressing , you can see the total weight of all loads on the
scale.
If you want to weigh more loads, just press
reading to '0' again.
• Waste batteries should not
disposed of with household
waste.
• Please check with your local
authority for battery recycling
advice.
is pressed. ---------
to reset LCD