Programming Of Functions - AVE AF902R-CE Manual

Programming of FUNCTIONS

It allows entering the system functions. To enter functions press keys
to the selectioned function.
When inserting the JP1 jumper seated on the inner card (see figure at page 46) in the INST
position, the programming of all the functions of the dialler is fully enabled.
By moving jumper JP1 to the UT position, the user is not allowed to enter the most sophisti-
cated functions, as shown in the single programming procedures, which are used only for
the initial connection.
The available functions are the following:
• Function 1: recording, listening and change of MESSAGE 1
• Function 2: recording, listening and change of MESSAGE 2
• Function 3: setting, display and change of USER CODE
• Function 4: network search time programming (15 or 30 seconds)
• Function 5: GSM telephone system testing
• Function 6: activation of the operating cycle related to CHANNEL 1 for battery voltage
lower than THRESHOLD 1.
• Function 7: storing of radio codes CODE 1 ÷ CODE 4 related to control panels, remote con-
trols and detectors for controlling the operating cycle related to CHANNEL 1.
• Function 8: storing of radio codes CODE 5 ÷ CODE 8 related to control panels, remote con-
trols and detectors for controlling the operating cycle related to CHANNEL 2.
• Function 9: Block of the operating cycle in progress by pressing any key.
- 33 -
÷
1 8
related