Operation - Eastwood 21491 Instructions Manual

INSTALLING PEDAL RETURN HOOKS [H] AND SPRING [J] (FIG 14).
• Thread one each M3 Nut onto the Hooks [H] leaving 1/4"- 3/8" thread
exposed.
• Thread the Hooks [H] into the threaded holes in the Post Assembly and Pedal
Assemblies [B & C].
• Slip a loop of the Pedal Return Spring [J] over a Hook, lift up on the Pedal
Assembly then slip the opposite loop over the remaining hook (FIG 15).
ATTACH FOOT PEDAL ARM LOCKPIN [K] (FIG 16).
The Shrinker/Stretcher Jaws can be permanently damaged by coming into direst
contact without a strip of metal or protective material between them.
The Lockpin [K] should be used for storage
• Push one leg each of the two Cotter Pins [L] through the end links of the
Chain [M].
• Insert the legs of one Cotter Pin through the hole of the Lock Pin [K] then
flare them out.
• Insert the legs of the 2nd Cotter Pin through the hole in the right side of the
triangular section of the Post Assembly then flare them out (FIG 16).
The Eastwood Shrinker Stretcher Foot Pedal Stand is now ready for use.
INSERT FOOT PEDAL ARM LOCKPIN [K] FOR TRANSPORT AND STORAGE
(FIG 17)
The Shrinker/Stretcher Jaws can be permanently damaged by coming into direct
contact with each other without a strip of metal or protective material between
them. The Lockpin [K] is intended to be inserted into the Post Assembly and Foot
Pedal Arm when not in use and should always be used when moving the Stand and
for storage.

OPERATION

Read the Eastwood Elite Deep Jaw Shrinker Stretcher (#21489, not included)
Instructions including all safety notices carefully before attempting to operate this
Eastwood Shrinker Stretcher Stand.
If these instructions are unavailable, contact The Eastwood Company at:
www.Eastwood.com or call 1-800-345-1168 and request document #21489Q.
To order parts and supplies: 800.343.9353 >> eastwood.com
FIG. 14
FIG. 15
FIG. 16
FIG. 17
7