Disassembling Instructions - Nokia NPM-6 Series Disassembly And Assembly Instructions

CCS Technical Documentation

Disassembling instructions

Note! It is only allowed to reassemble C-Cover (phone) once. For second reassem-
bling use of new C-Cover is mandatory! Use new screws in general.
Press the grip markings on both sides of the B-Shell and
remove B-Shell.
3
4
Tightening torques for screws (Note! Two tightening
torques!): -screws 1-4, use 40 Ncm
-screws 5-6, use 25 Ncm.
Tightening order for screws is from 1 to 6. When
tightening the screws 5 and 6 it is necessary to press
strongly the system connector against C-cover to avoid
sealing tape twisting in the system connector. If the
sealing tape twists with screwassembly it is not
waterproof anymore. Note! The screws can be assembled
only once.
Separate the UI-Module from Radio Module carefully,
because of the board-to board-connector.
Issue 2 06/03
1
5
6
2
CopyrightNokia. All rights reserved
Disassembly and Assembly Instructions
To remove the A-Shell press Locking Springs as shown and
pull A-Shell from the unit.
Remove engine from C-Cover.
Use tweezers to remove Vibra Motor.
NPM-6/6X
Page 3