Fluigent PRESSURE UNIT User Manual page 2

PRECAUTIONS
Aria is a perfusion system which automates perfusion or timed
Do not open PRESSURE UNIT device. Please refer all service issues to
injection protocols. It allows for the sequential delivery of up to 10
our Support department (support@fluigent.com)
different solutions at the desired flow rate into a microfluidic chip,
perfusion chamber or petri dish.
Prevent any objects or liquid from entering the PRESSURE UNIT. This
may cause a short-circuit or other malfunction. Failing to follow these
instructions may:
• Expose the user to direct current/voltage if the device is powered.
This may lead to damages.
• Void device's warranty
• Discharge our company from any liability regarding physical or
device damages.
Place the product in an stable location with a level surface and good
support.
If using the PRESSURE UNIT with other flow control systems than
Fluigent pressure controllers, please check that the pressure in your
fluidic system does not exceed the maximum pressure of the sensor
being used.
Ensure to connect the PRESSURE UNIT to the PC before launching the
software. Make sure to properly clean the fluidic path and disconnect
the device from the PC to remove power supply.