Table of Contents
Advertisement
Steps
1. Connect the power-adapter port cable to the system board.
2. Adhere the tape that covers the power-adapter port connector on the system board.
3. Route the power-adapter port cable through the routing guides on the palm-rest and keyboard assembly.
4. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
5. Close the right-display hinge and align the screw holes on the right-display hinge with the screw holes on the system board.
6. Replace the two screws (M2.5x5) that secures the right-display hinge to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
3-cell battery
4. Remove the
M.2 2230 solid-state
5. Remove the
M.2 2280 solid-state
6. Remove the memory.
7. Remove the
wireless
card.
8. Remove the
heat
sink.
About this task
The following image indicates the connectors on your system board.
After working inside your
Before working inside your
or the
4-cell
battery, whichever applicable.
drive.
drive.
computer.
computer.
Removing and installing components
51
Advertisement
Table of Contents
