Advertisement
1.
Connect a computer and TC3420 on the same network.
2.
Power up the TC3420 and the "LINK" LED should be on. (You can disable the alarm by
setting the "DISALM" to the down (on) position.)
3.
Start your Web browser.
4.
In the Address box, enter the IP address of the TC3420. For example, if the unit is set to
default Master, enter: http://192.168.254.123
If the unit is set to default Slave, enter: http://192.168.254.124
5.
Once connected, you should see a dialog box as in figure 10, next page. Enter the username &
password and click enter, then you will see the following figure 9.
6.
Click the links at the left of the page to navigate to the desired section.
Note:
The Web Configuration Interface will not be accessible while the TC3420's are transmitting or
receiving serial data. Otherwise, it is accessible. (Such as when the units are idle)
(Please refer to "Testing & Trouble shooting" section, if not connected)
- 18 -
Advertisement
