Advertisement
Dynamic IP (DHCP)*:
DHCP (Dynamic Host Configuration Protocol) option is for Slave unit only. It enables the Slave unit to get
a temporary or permanent IP addresses (out of a pool) from a DHCP server.
In order to use the DHCP function, there should be a DHCP server residing at the user's local area network.
If DHCP server is not available, the Slave unit's IP address must be Static. Please refer to the "Static IP"
section for more information.
Before you turn on the DHCP option, you need to enter the Master's IP address at the "Remote IP" field
on the "Settings" page for the Slave Unit.
Example:
TC3420: (Slaves)
Please do the following after the "Master IP" has been set on the Slave units.
1. Power off the unit.
2. At the front panel, set "DHCP" DIP switch to on (down) position.
3. Power up the unit.
The following fields will be replaced by the data getting from DHCP server automatically, and user's data
will be ignored.
The "DHCP" LED will flash when the unit is obtaining the network settings from the DHCP server and the
LED turns solid after the unit gets the settings.
*Note: Not used, for future release.
- 12 -
Advertisement
