Steam Ironing; Steam Shot - Water Spray; Dry Ironing; Cleaning - G3 Ferrari APOLLO G40015 User Manual

2) Select the temperature regulator (10) according to the symbols shown on the previous page. The chosen
symbol has to be aligned with the mark placed on the tank. The iron plate temperature control light
shows that iron plate (8) is warming up. Wait until light turns off to start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is constant. If
you lower the thermostat, do not start ironing until the iron temperature control light turns off.

STEAM IRONING

Before using the steam check that the water contained in the tank is enough. Adjust steam power using the
control knob (3). Place the steam control knob between minimum and maximum depending on the amount of
steam required and temperature.
Caution: the iron provides continuous steam only if it is held in a horizontal position and if the plate is hot. It
is possible to stop the continuous jet of steam by placing the iron vertically or placing the steam control (3) to
"0". To avoid the dripping of water, it is recommended to only use steam at high temperatures.
STEAM JET – WATER SPRAY
Steam jet
: press the steam-shot button (4) for having a vigorous jet of steam which can penetrate the fibers
and soften even the most stubborn creases. Wait a few seconds before pressing.
By pressing the button periodically is also possible to freshen up curtains, hanging clothes, etc ...
Caution: the steam shot function can only be used at high temperatures; stop the jet when the temperature
control light lights up, start again when it goes out.
Water spray
: press the water spray button (5) slowly for having dense spray; press fast for vaporized spray.
Caution: make sure there is water in the tank. For delicate fibers it is advisable to moisten the article before
using the spray. To prevent stains, do not use the spray over silk and synthetic fibers.

DRY IRONING

To perform dry ironing, move the steam regulator (3) in "0" position. In this position, the steam emission is
disable, otherwise the water spray option is still unable.

CLEANING -

Before cleaning any part of the product, ensure that the unit is unplugged from the
electrical outlet and the ironing plate isn't hot anymore.
Any leftovers on the ironing plate can be removed with a damp cloth or with a non-abrasive detergents. Do
not scrape the ironing plate with iron sponge or metal objects. The plastic parts can be cleaned with a damp
cloth and neutral detergent, then wiped with a dry cloth. Do not immerse the unit in water.
Self-cleaning
: the use of this function every 10-15 days is recommended. The auto-cleaning removes
impurities and lime scales inside the holes of the plate. Follow the steps:
•
Fill the tank up to the maximum level and place the steam regulator (3) to maximum level.
•
Set the temperature controller (9) up to the maximum (MAX) and wait for the control light (8) to turn off.
•
Disconnect the power plug from the socket and hold the iron horizontally over a sink.
•
Press and hold self-cleaning button (13), shaking gently, until all the water and steam come out.
•
When the plate has cooled down, wipe it with a damp cloth.

BEFORE STORING

•
Unplug the system from the outlet.
•
Empty the water tank by turning the device upside down and shake it gently.
•
Allow the plate to cool down completely.
•
Wrap the power cord in the back of the body. Leave the electric iron vertically.

TECHNICAL FEATURES

•
Power supply: AC 230V~50-60 Hz. 2200W power
•
Water tank capacity: 370 ml
13