Table of Contents
Advertisement
Das Geraet hat ein Sicherheitsystem der aufschaltet das Geraet automatisch auf wenn der Bugeleisen
bleibst unverwendet in horizontale Position fuer 30 Sekunden oder 7 Minuten vertical oder auch 30
Sekunden nach es gefallen ist. Es ist genügendes Bewegen das Eisen dafür, den Eisen betr.-Anfang zu
lassen, der funktioniert.
24
IRONING TEMPERATURE
Always check fi rst to see whether a label with ironing instructions is attached to the article to be ironed.
Follow these ironing instructions in all cases.
If ironing instructions are missing but you know the kind of fabric, then see the table below.
Sort the laundry out according to ironing temperature fi rst: wool with wool, cotton with cotton, etc. Start
ironing the fabrics requiring the lowest temperature and progress to the higher ones because the iron
heats up quicker than it cools down.
If the fabric consists of various kinds of fi bres (e.g. cotton with polyester), you must always select the
lowest ironing temperature of the composition of those fi bres.
If you do not know what kind(s) of fabric(s) the article has been made of, fi nd a spot which will be invisi-
ble when wearing or using the article. Try out the ironing temperature which is most suitable there.
(Start at a relatively low temperature).
Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. Preferably set
the steam control to maximum position and use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be prevented by turning
the article inside out and ironing the reverse side.
Velvet and other textures which rapidly acquire shiny spots should be ironed in one direction only (with
the nap) applying light pressure.
Always keep the iron moving.
Silk and other fabrics likely to become shiny should be ironed on the reverse side. To prevent staining do
not use the spray on silk or other delicate fabrics.
SETTING THE TEMPERATURE
Insert the plug in the wall socket and stand the iron upright.
Select the desired temperature with the temperature pulse button (1), following the instructions indicated
on the label of the suite or on the scheme of the iron
17
Advertisement
Table of Contents
