Setup; Adsl Settings - NETGEAR JDGN1000 User Manual

There are 2 primary methods used in the Wi-Fi Protected Setup:
- PIN entry, a mandatory method of setup for all WPS certified devices.
- Push button configuration (PBC), an actual push button on the hardware or through
a simulated push button in the software. (This is an optional method on wireless
client).
If you are using the PIN method, you will need a Registrar (access point/wireless
router) to initiate the registration between a new device and an active access
point/wireless router. (Note: The PBC method may also need a Registrar when used
in a special case where the PIN is all zeros)
In order to use the push-button for WPS authentication, you must ensure that the
network card support the function. if it supports, you need not to do any configuration.
You can press the WPS button directly to enable the WPS function

5.3 Setup

Choose Setup and the submenus of Setup are shown as below:

5.3.1 Adsl Settings

Choose Setup > Adsl Settings and the following page appears.
In this page, you can add or remove the DSL ATM Interfaces.
Click the Add button to display the following page.
NETGEAR JDGN1000 User Manual
Figure 19 Add WPS Client
Figure 20 Submenus of Setup
Figure 21 DSL ATM interface configuration
17