NSC/W–1/3
PAMS
Disassembly & Troubleshooting Instructions
Technical Documentation
Power doesn't stay on, or phone is jammed
If this kind of fault has come after flash programming, there are most prob-
ably open pins in ICs.
The soldered joints of ICs: D202 (MAD1), D201 (FLASH), N150 (CCONT),
D200 (SRAM) are useful to check first.
Normally the power will be switched of by CCONT (N150) after 30 seconds,
if the watchdog of the CCONT can not be served by software.
The watchdog updating can be seen by oscilloscope at pin 50 (DataselX) of
CCONT.
In a normal case there is a short pulse from "1" –> 0 every 8 seconds.
The power off function of CCONT can be prevented by connecting a short
circuit wire from CCONT pin 29 to ground.
Original 11/99
Page 14