Table of Contents
Advertisement
Najo
Backboards by Ferno
®
5.1 Maintenance Schedule
The backboard requires regular maintenance. Set up
and follow a maintenance schedule.
The schedule at the right represents minimum
maintenance. A sample maintenance record sheet is
provided on page 11.
When using maintenance products, follow the
manufacturers' directions and read the manufacturers'
material safety data sheets.
5.2 Disinfecting the Backboard
Wipe or spray all surfaces of the backboard with
disinfectant. Follow the disinfectant manufacturer's
directions.
Ferno recommends inspecting the backboard for obvious
damage as you disinfect it.
5.3 Cleaning the Backboard
1. Clean all surfaces of the backboard with warm
water and a mild detergent. If necessary, use a
stiff-bristled brush (but not a wire brush).
2. Rinse the backboard with warm water.
3. Dry the backboard with a towel or allow it to
air dry.
5.4 Inspecting the Backboard
Have your service technician check the following:
q Is the backboard free of cracks, crevices, and
punctures?
q If the backboard is fitted with speed clip pins,
are all pins solidly in place and free of cracks
or damage?
If inspection shows damage to any part of the
backboard except the speed clip pins, remove the
backboard from service and destroy it to prevent
accidental use. Speed clip pins are replaceable; see
information at right.
© Ferno-Washington, Inc. 234-3237-00 February 2006
5 - MAINTENANCE
Disinfecting (this page)
Cleaning (this page)
Inspecting (this page)
Improper maintenance can cause injury.
Maintain the backboard only as described
in this manual.
Improper parts can can cause injury. Use
only Ferno parts on the backboard.
Do not attempt to repair the backboard except
to replace speed clip pins. Repairs to the
backboard
performance and will void the warranty.
Use Parts Kit 090-5802 to replace damaged or missing
speed clip pins for Najo Backboards by Ferno.
In the U.S.A. and Canada, order the replacement
pin kit from EMSAR at:
Outside the U.S.A. and Canada, contact your Ferno
distributor or call Ferno Customer Relations
+1.937.382.1451.
Maintenance Schedule
WARNING
!
WARNING
!
Important
can
cause
SPEED CLIP PIN REPLACEMENT KIT
1.800.73EMSAR (Phone)
1.937.383.1051 (Fax)
www.EMSAR.com (Internet)
Maintenance
•
•
•
•
unpredictable
9
Advertisement
Table of Contents
