Operation Notes For Work Lamp; Maintenance; Warranty - PRO-PULSE CT119-C Operator's Manual

OPERATION NOTES FOR WORK LAMP

ON/OFF
To turn the worklight ON, simply slide the ON/OFF switch up. To turn the
worklight OFF, simply slide the ON/OFF switch down.
TO SWIVEL THE WORKLIGHT
1. To swivel the head of the worklight, hold the worklight with two hands. One
hand should be around the body of the light; the other hand should be
around the head of the worklight.
2. Using the hand that is holding the head of the worklight, twist the head clockwise.
Continue to adjust the light until it is adjusted to the angle that works for your job.
3. To return the worklight to its original position, twist the worklight in a counter-
clockwise direction.
TO REPLACE THE LIGHT BULB
To change the light bulb, hold the top of the light with one hand and the rim of the
worklight with the other. Using the hand that is holding the rim of the worklight,
begin turning it in a counter-clockwise direction. Continue to turn the rim until
it separates from the body of the worklight. Use care when doing this to avoid
damaging th e reflector or the protective lens over the worklight. The burnt out
bulb should be removed and discarded appropriately. Replace the bulb and
carefully align the rim and light assembly with the worklight body. Begin twisting
the rim in a clockwise direction.
WARNING: Always remove the battery pack from your Cordless tools when you
are assembling parts, making adjustments, assembling or removing blades,
cleaning or when not in use. Removing the battery pack will prevent accidental
starting that could cause serious personal injury.
Keep the tool housing and handle clean and free of oil and grease using
1.
mild soap and a damp (not wet) cloth. Do not let solvents like brake fluid,
gasoline, petroleum-based products, etc., contact plastic parts of the hous-
ing. Cleaning with these substances can harm the plastic and compromise
the integrity of the double insulating system.
2.
Keep the vents clear of dust and debris. This will help prevent possible elec-
tric shorts and ensure proper cooling.
3.
Avoid overloading your tool. Do not force the tool, otherwise it will become
hot and lose efficiency. Running it free of load for a minute or two will allow
it to cool itself to normal temperature.
4.
Lubrication for these tools is done at the factory and should not be neces-
sary again under normal use.
5.
An authorized repair centre should do any repairs, modification, or mainte-
nance that involve opening or disassembling tools.
6.
Any damage to the tools should be corrected at an authorized repair centre.

WARRANTY

Thank you for investing in a Pro-pulse power tool. These products have been
made to demanding, high-quality standards and are guaranteed for domestic use
against manufacturing faults for a period of 12 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of
your tool (failure, missing part, etc.), please contact one of our service technician
at our toll free service line at 1 888 874-8661 from 8 AM to 6 PM, Monday to
Friday, Eastern time. RONA reserves the right to repair or replace the defective
tool, at its discretion.
Normal wear and tear, including accessory wear, is not covered under guarantee.
The product is guaranteed for 12 months if used for normal trade purposes. Any
guarantee is invalid if the product has been overloaded or subject to neglect,
improper use or an attempted repair other than by an authorized agent. Heavy-
duty, daily professional or hire usage are not guaranteed. Due to continuous
product improvement, we reserve the right to change the product specification
without prior notice.
24
CT119-C

MAINTENANCE

!