Operating Instructions - Flex CL 2000 18.0 Instruction Manual

CL 2000 18.0

Operating instructions

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Before switching on the power
tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Inserting/replacing the battery
1. Press the charged battery into the
power tool until it clicks into place.
2. To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
1. Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Switching on and off
CAUTION
Ó Never direct the nozzle of the power tool
at other persons or yourself.
Ó Use personal protective equipment:
safety goggles, ear defenders and also
a respirator (or breathing protection) if
dust is agitated during operation of the
power tool. It is also recommended to
wear suitable footwear, long trousers and
gloves while working with the power tool.
Ó Keep hair and clothing away from
openings and moving parts.
Instruction manual
9