Advertisement
I. INSTALLATION
PROCEDURE
1) The Paper Handling Controller is
installed in the slot on the right side of
your printer's motherboad, when facing
the rear of the motherboad, as shown
below.
Figure 2-1-1
2) Place the motherboad on a flat surface
and remove the cover with a screwdriv-
er
.
Figure 2-1-2
3) Press down on the connector and insert
the protruding part of the controller
boad into the slot, as shown below.
Figure 2-1-3
4) Attach the cable by pressing the con-
nector into the slot at the rear of the
Paper Handling Controller.
Figure 2-1-4
CHAPTER 2
2 - 1
Advertisement
