To Cancel Pairing; Rf Change Setting; Changing The Rf Output Power - Sony DAV-HDX587WC Operating Instructions Manual
Home theater systems: sony® bravia® theater system
Hide thumbs
Also See for DAV-HDX587WC:
- Quick setup manual (2 pages) ,
- Specification sheet (2 pages) ,
- Addendum sheet (2 pages)
Table of Contents
Advertisement
When sound transmission is established,
"PAIRING" and "COMPLETE" appear
alternately in the front panel display.
x For the S-AIR receiver
Refer to the operating instructions of the
S-AIR receiver.
When sound transmission is established,
"PAIRING" and "COMPLETE" appear
alternately in the front panel display.
Note
• Perform pairing within several minutes of Step
5. If you do not, "PAIRING" and
"INCOMPLETE" appear alternately in the front
panel display. To continue pairing, press
start again from Step 5. To cancel pairing, press
SYSTEM MENU.
7
Press SYSTEM MENU.
The system menu turns off.
Note
• After you have performed pairing, if you select
"S-AIR ID" (page 69), the ID setting ("A," "B," or
"C") that you last used is displayed first by default.
To cancel pairing
Perform the ID setting of the unit according to
the procedure of "To set the ID of the unit." If
you select a new ID, pairing is canceled.
If sound transmission is
unstable
For the surround amplifier
For the S-AIR receiver
If you use multiple wireless systems which share
the 2.4 GHz band, such as wireless LAN or
Bluetooth, the transmission of S-AIR products
or other wireless systems may be unstable. In
this case, the transmission may be improved by
changing the following "RF CHANGE" setting.
1
Press SYSTEM MENU.
2
Press X/x repeatedly until "RF
CHANGE" appears in the front panel
display, then press
3
Press X/x to select the desired setting.
• "AUTO": Normally select this. The
system changes "RF CHANGE" to "ON"
or "OFF" automatically.
70
US
and
or c.
• "ON": The system transmits sound by
searching for the better channel for
transmitting.
• "OFF": The system transmits sound by
fixing the channel for transmitting.
4
Press
.
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
6
When you set "RF CHANGE" to "OFF,"
select the ID so that sound
transmission is most stable (page 67).
Note
• In most cases, you will not need to change this
setting.
– If "RF CHANGE" is set to "OFF," transmission
between the unit and S-AIR sub unit can be
performed using one of the following channels.
– S-AIR ID A: equivalent channel for IEEE
802.11b/g channel 1
– S-AIR ID B: equivalent channel for IEEE
802.11b/g channel 6
– S-AIR ID C: equivalent channel for IEEE
802.11b/g channel 11
• The transmission may be improved by changing the
transmission channel (frequency) of the other
wireless system(s). For details, refer to the operating
instructions of the other wireless system(s).
Changing the RF output power
(Only when using the EZW-RT10A
wireless transceiver.)
1
Press SYSTEM MENU.
2
Press X/x repeatedly until "RF
POWER" appears in the front panel
display, then press
3
Press X/x to select the desired setting.
• "HIGH": Normally select this.
• "LOW": The RF output power is
decreased.
4
Press
.
The setting is made.
5
Press SYSTEM MENU.
The system menu turns off.
or c.
Advertisement
Table of Contents
